yeah some buddy, i'll b giving both 1/2 & O offset a burl, still have lots of good ones i'll flog of cheap.

yeah kit shell mate, not 2 bad at all, pretty happy with the whole kit buddy, quality of plastics, helical cut crownwheel & pinion, lightweight outdrives etc all look good and went together pretty well, it is the 1st pro kit here so there r a couple minor glitches in the build but over all very tight when all together, about 6 mm longer than the HongNor,should b ready 4 K.O.T.V.but im flat out with work and it will need some serious hacking to loosen it up a bit those two 'c' clips r the only 2 on the truck &will b soon upgraded..

don't tell me its another f.t.m.y. kit scotty lol

lol, no all the machining was finished buddy, just things like excess flashing on the plastic etc, alloy centre diff mount took a little tweaking to got it perfect, thats about it, c ya soon buddy.

http://www.morcc.com.au/smf/index.php?a ... 86;preview will post a rundown of the new Caster K8t factory roller after this sundays meet including build,quality,fitnfinish,wear n tear + upcomming changes and possible change to RB racing engines, personally impressed with its 1st run since i hadnt started the truck up until the 5mins to the 1st heat signal, dam job,stay tuned, Scotty...TEAM CASTER